Theses/Project Reports from 2016
Removing Oil from Fried Foods via Mechanical Process, Yufay Chow-Yee
Experimentation of Mode I and Mode II Fracture of Uni-Directional Composites and Finite Element Analysis of Mode I Fracture Using Cohesive Contact, Joseph Daniel Garrett
The Effects of Obesity on Resultant Knee Joint Loads for Gait and Cycling, Juan Gutierrez-Franco
Torsional Stiffness and Natural Frequency Analysis of a Formula SAE Vehicle Carbon Fiber Reinforced Polymer Chassis Using Finite Element Analysis, Manuel Herrmann
A Study of Constant Voltage Anemometry Frequency Response, Alex D. Powers
Physical Testing of Potential Football Helmet Design Enhancements, Michael Jeremy Schuster
Design and Analysis of a Lift Assist Walker, Deep P. Shah
Design and Testing of a Novel Adhesion and Locomotion Method for Wall Climbing Vehicles, Jim R. Stefani
Numerical Development and Optimization of a Phase Change Material Solar Thermal Storage Unit System Model, Jared Tower
Design and Analysis of the Impact Diffusion Helmet Through a Finite Element Analysis Approach, Steven Paul Warnert
Theses/Project Reports from 2015
A Finite Element Analysis of Tibial Stem Geometry for Total Knee Replacements, Aaron Isidro Bautista
Aerospike Rocket Motor Structural Webbing, Andrew Brock
Sparse Aperture Speckle Interferometry Telescope Active Optics Control System, Matthew Clause
Development and Validation of a Tibiofemoral Joint Finite Element Model and Subsequent Gait Analysis of Intact ACL and ACL Deficient Individuals, Nicholas Czapla
Development of Local Transient Heat Flux Measurements in an Axisymmetric Hybrid Rocket Nozzle, Christopher D'elia
Vibration-Based Health Monitoring of Rotating Systems with Gyroscopic Effect, Nenad Gavrilovic
Benchmarking, Characterization and Tuning of Shell EcoMarathon Prototype Powertrain, Eric J. Griess
Three Degree-of-Freedom Parallel Actuator Telescope Mount, Garrett Daniel Gudgel
Eight Degree of Freedom Vehicle Model with Pitch, Yaw, Tire Control and Sensor Inputs, Sean T. Hirtle
Mathematical Model Validation of a Center of Gravity Measuring Platform Using Experimental Tests and FEA, Michael Lashore
Development of an Autonomous Single-Point Calibration for a Constant Voltage Hot-Wire Anemometer, Ryan Murphy
Aerodynamic Design and Structural Analysis Procedure for Small Horizontal-Axis Wind Turbine Rotor Blade, Dylan R. Perry
Analysis of a Carbon Fiber Reinforced Polymer Impact Attenuator for a Formula SAE Vehicle Using Finite Element Analysis, John T. Rappolt
Increasing Isentropic Efficiency with Hydrostatic Head and Venturi Ejection in a Rankine Power Cycle, Nathan Daniel Ruiz