Theses/Project Reports from 2019
Hybrid III 95th Percentile Large Male Finite Element Model Neck Alteration, Eric Riley Day
A Methodology for Verification of Structural Standards for a Seating System by Finite Element Analysis, Zachary Kelly Dworaczyk Wiltshire
A Rotating Aperture Mask for Small Telescopes, Edward L. Foley
Comparison of LQR and LQR-MRAC for Linear Tractor-Trailer Model, Kevin Richard Gasik
Dynamic Pressure Sensing for the Flight Test Data System, Marc Y. Goupil
Atmospheric Water Harvesting: An Experimental Study of Viability and the Influence of Surface Geometry, Orientation, and Drainage, Carson T. Hand
Compact Rake Boundary Layer Data System Module, Nathan Jeffry Hoyt
Effects of Bio-Composites in Corrugated Sandwich Panels Under Edgewise Compression Loading, Jalen Christopher Mano
Comparison of Modern Controls and Reinforcement Learning for Robust Control of Autonomously Backing Up Tractor-Trailers to Loading Docks, Journey McDowell
Design of a Low-Cost Data Acquisition System for Rotordynamic Data Collection, Gregory S. Pellegrino
Fracture Control Modeling with the Finite Element Method, Jorge A. Pluma Reyes
Design, Modeling and Control of a Two-Wheel Balancing Robot Driven by BLDC Motors, Charles T. Refvem
Dynamic Response Validation of CubeSats Through Testing and Finite Element Analysis, Peter Rivera
Investigation of Design, Manufacture, Analysis, and Test of a Composite Connecting Rod Under Compression, Thomas Juhl Rohrbach
Viewpoint Optimization for Autonomous Strawberry Harvesting with Deep Reinforcement Learning, Jonathon J. Sather
Development of a Model and Imbalance Detection System for the Cal Poly Wind Turbine, Ryan Miki Takatsuka
Stationary Exercise Bicycle Instrumentation and Verification of OpenSim Pelvic Residual Loads in Seated Cycling, Bradley Robert Wash
Optimal Direct Yaw Moment Control of a 4WD Electric Vehicle, Winston James Wight
Flight Test Data System for Strain Measurement, Zachary David Wilson
Carbon Nanotube (CNT) Coated E-glass Fibre Sensor for Structural Health Monitoring of Composite Materials, Sidney Wong
Theses/Project Reports from 2018
Manufacture of Complex Geometry Component for Advanced Material Stiffness, David Russell Bydalek
Effect of Aerogel on the Thermal Performance of Corrugated Composite Sandwich Structures, Jacob Dillon Chess
Defect Detection in Selective Laser Melting, Moira Foster
The Development and Validation of SINATRA: A Three-Dimensional Direct Simulation Monte Carlo (DSMC) Code Written in Object-Oriented C++ and Performed on Cartesian Grids, David Matthew Galvez